How do I use Flex Shot? Official Site
/Q: How do I use Flex Shot?

Q: How do I use Flex Shot?

Flex Shot™ is so easy to use! Just follow these simple steps:

  1. All surfaces must be clean, dry and free from dirt, grease and oil.
  2. Hold can at a 45-degree angle, push against the nozzle and apply directly to the area to be treated. For a perfect bead, apply in a steady, even motion. Adjust your speed to control the thickness of the bead.
  3. If further tooling is required, complete within 5 minutes. Remove excess sealant immediately with a dry paper towel.
  4. After using, extend a small amount of material beyond the end of the nozzle. This will cure and form a seal for the remaining material. Pull out this cured plug when you are ready to use again.
2019-02-25T16:41:33+00:00